WEEK 7 (FYP 2)

 Tuesday, September 1, 2020

WEEK 7 FYP 2 ( TEST THE INPUT TO CONTROLLER  AND CONTROLLER TO OUTPUT)

Objectives:

1) To test the interfacing between the input to controller.

2) To test the feedback from controller to ouput.

Methodology:

1) Run the circuit from the source and connect to the controller.

2) From the controller connect to the IOT part.

Result:

This picture show that the solar panel and wind turbine were connected to the connector on the main board of the project. From the connector, it connect to the controller circuit. So, here the circuit was works very well.

This picture show that the reading for solar panel and wind turbine on the digital meter and Blynk app. The reading on digital meter was on the input part that mean it read the incoming source of voltage and current directly with complete wiring while for the Blynk app it show for the output part and it connected by using WiFi.

Analysis nad Discussion:

As a conclusion, the objective for this week was succeed and i can take a rest for my weekend for a while. hehehehehe.....