WEEK 5 (FYP 2)

 Wednesday, August 19, 2020

WEEK 5 FYP 2 (CONSTRUCT AND TEST EACH BLOCK OF THE CONTROLLER, INPUT AND OUTPUT)

Objectives:

1) To construct all the component for this project.

2) To test for each block of input, controller and output.

Methodology:

1) Separated the component from input, controller and output.

2) Construct the circuit or equipment one by one until finish

3) Test all the constructed circuit and the body for the project.

Result:

The solar panel that i choose is 10W and i expose it to the spotlight. It is because i want to measure the reading of the input voltage from that radiation and at the same time i want to charge the battery using solar charger controller.

This is my second source which is wind turbine. This turbine i use is 220VAC 45W. I use a bottle then i adjusted it become blades to spin and generate the input voltage from wind turbine. I put it beside solar panel. I also use the blower to rotates the blades because my area does not give enough wind energy to rotates the blades.

This is the arrangement for the component for my project for the 1st time when all the equipment were connected.

This is the the reading for my monitoring system on BLYNK app that connected through the WiFi. The Node MCU 8266 was built in with WiFi module, so it easy connect by using any device.

Analysis and Discussion:

For this week, the progress of my project was good because i managed to construct all the circuit and arranged all the equipment include the big model for my project. I hope the next week i managed to troubleshoot any problem happen.

Conclusion:

As the conclusion, i was exceed the objective for this week and hopefully my upcoming week also will be like this.